Finance | Project Operations, Human Resources, ...

Unable to bulk remove lines from a Voyage in Landed Cost module

(2) Share

Report

Posted on by KK-12030320-0

Hi everyone,

I am experiencing an issue with the Landed Cost module in Dynamics 365 Supply Chain Management.

In the "All voyages" or "Voyage editor" screen, I am trying to remove multiple items (PO lines) from a voyage at once. However, as soon as I select more than one line, the "Remove" button becomes disabled (greyed out). It only stays active when a single line is selected.

Is this the intended behavior (by design), or is there a specific setting to enable bulk removal?

Manually removing hundreds of lines one by one is extremely time-consuming. Does anyone know a workaround or a way to perform a bulk delete?

Any advice would be greatly appreciated. Thanks!

Categories:

Dynamics 365 Finance

I have the same question (0)

All responses (4)

Answers (0)

Suggested answer

André Arnaud de Cal... 303,139 Super User 2026 Season 1 on at

Like (2)

Report
Copy link

Link copied!

Hi,

You can try a workaround. Go to the module Landed Cost. Then open Inquiries > Voyage lines. At the top-right of the page, there is an option to open the voyage lines in Excel. This will download an Excel sheet with a Dynamics 365 connector enabled. When you log in, you can delete rows from the Excel sheet and Publish the changes.

Was this reply helpful? Yes No
Suggested answer

Giorgio Bonacorsi 1,486 on at

Like (1)

Report
Copy link

Link copied!

Hello,

What is the current status shown on the voyage line status? Because probably the voyage is "in transit", we cannot delete.

Let's us know the status and the case context, and we can discuss about which is the best way to face it.

Thank you,

Giorgio

Was this reply helpful? Yes No
Suggested answer

Syed Haris Shah 1,102 Super User 2026 Season 1 on at

Like (2)

Report
Copy link

Link copied!
Hi @KK-12030320-0,

You’re right, if you select multiple lines in Voyage, the Remove button gets disabled, so you can’t delete them normally. But there’s a hidden trick:

Select the lines

Press ALT + F9

Boom-they’re gone 😄

The solution provided by @André Arnaud de Calavon should also work in your case.

If you find this answer helpful, please consider verifying the answer. 👍

Regards,

Syed Haris Shah

Was this reply helpful? Yes No
Syed Haris Shah 1,102 Super User 2026 Season 1 on at

Like (0)

Report
Copy link

Link copied!

Hi @KK-12030320-0,

If you have any updates, please share them here.

Regards,
Syed Haris Shah

Was this reply helpful? Yes No