Remaining Quantity

(0) Share

Report

Posted on by Rad22

Good day,

We currently experience an issue when we perform reclassments on Navision4 that a remaining quantity stays open incorrectly.

The reclassment is to change the quality status from blocked stock to sellable stock.

What we experience is that the reclassment is performed successfully and stock is released in the system to be sold. But in the Item Ledger entries the quantities remain open as remaining quantities inflating the system stock and will result in a stock loss if we down adjust.

In the example below, we performed a reclassment for 384 units. Item tracing indicates 384 units was successfully reclassed

Applied entries however only shows 276 applied and now leaves 108 remaining thus inflating our stock

Any suggestions where to look to fix this or to understand why this happens?

I have the same question (0)

All responses (1)

Answers (0)

Community Member on at

Like (0)

Report

RE: Remaining Quantity

Hi Rad22,

Please post this thread at the Dynamics NAV Forum.

Was this reply helpful? Yes No