Workflow Issue with condition

(0) Share

Report

Posted on by Mattw112b

385

D365

I would like to create a single ribbon workbench ribbon button to set an opportunity to on hold or in progress.

I created a workflow thinking I could have the button kick off the workflow.

I want two separate actions to potentially occur.

Button pressed > If Record is not on hold, put it on hold. If it is on hold set it to in progress.

I created a workflow shown below with two conditions. However, right now it always is doing both conditions because it comes in sets record to in progress, so then the other condition thinks it is in progress and puts it back to on hold. So it always gets put on hold?

Can I only do one condition that can logically do this or that?

Categories:

Customization / Solutions / SDK and API

All responses (1)

Answers (1)

Verified answer

Mattw112b 385 on at

Like (0)

Report

RE: Workflow Issue with condition

Sorry, never mind I found the conditional branch. Not sure why I didn't see that before.

Terry