Skip to main content

Notifications

Supply chain | Supply Chain Management, Commerce
Suggested answer

Report as finished error

(3) ShareShare
ReportReport
Posted on by 48
When I trying to report as finished on the batch order this error appears:

 
Knowing that we made many batch orders for this item with the same setup, and there are no changes done.
  • Abdulla Magdy Profile Picture
    Abdulla Magdy 48 on at
    Report as finished error
    Dear Sagar,
     
    So what should I do on the parameters if the formula lines cannot always be all consumed because the raw materials can have different specs like sometimes it can consume 100% but sometimes can be 95% only?
  • Suggested answer
    sagar_patil Profile Picture
    sagar_patil 651 Super User 2025 Season 1 on at
    Report as finished error

    This is true. Unless the formula lines and resources (route) are fully consumed, the system will not allow you to end the production/batch order. The consumption will obviously depend on your flushing principle.

    Make sure your posting parameters are defined correctly, such as the picking list and route card. If they are correctly set up, this error will not occur.

  • Abdulla Magdy Profile Picture
    Abdulla Magdy 48 on at
    Report as finished error
    Dear Danny,
     
    I found two unusual behaviors:
    1. After clicking on Process > Report as finished then from General I chose no for End job, the RAF is posted but the status has not changed.
    2. I realized that this happened when the picking list was consumed less than on the formula, so on the Formula lines I changed the estimated quantity to the actual picked quantity, so there is no remaining quantity, this could make me post the RAF
  • Danny Bilodeau Profile Picture
    Danny Bilodeau 4,324 Super User 2024 Season 1 on at
    Report as finished error
    Hi Abdullah,
    Does it happen when you do click on that Process>Report as finished menu in the ribbon?  Are you able to post a RAF journal directly?
  • Abdulla Magdy Profile Picture
    Abdulla Magdy 48 on at
    Report as finished error
    Hi Wael,
     
    there is no customizations related to production control module.
  • Waed Ayyad Profile Picture
    Waed Ayyad 7,245 Super User 2025 Season 1 on at
    Report as finished error
    Hi,
     
    Did you do any customization on the code?
     
     
    Thanks,
    Waed Ayyad

Under review

Thank you for your reply! To ensure a great experience for everyone, your content is awaiting approval by our Community Managers. Please check back later.

Helpful resources

Quick Links

Announcing Our 2025 Season 1 Super Users!

A new season of Super Users has arrived, and we are so grateful for the daily…

Vahid Ghafarpour – Community Spotlight

We are excited to recognize Vahid Ghafarpour as our February 2025 Community…

Congratulations to the January Top 10 leaders!

Check out the January community rock stars...

Leaderboard

#1
André Arnaud de Calavon Profile Picture

André Arnaud de Cal... 292,074 Super User 2025 Season 1

#2
Martin Dráb Profile Picture

Martin Dráb 230,900 Most Valuable Professional

#3
nmaenpaa Profile Picture

nmaenpaa 101,156

Leaderboard

Featured topics

Product updates

Dynamics 365 release plans