installation of planning optimization in Microsoft Dynamics 365 Finance and Operations
Views (1129)
Rahul Mohta
21,032
Like
Share
Reportinstallation of planning optimization in Microsoft Dynamics 365 Finance and Operations:
If you can run master planning by using your current license, you don't have to buy an additional license to start to use Planning Optimization.
To use Planning Optimization, one must install the Planning Optimization Add-in from your project in Microsoft Dynamics Lifecycle Services (LCS) and turn on the Planning Optimization functionality in Supply Chain Management
The requirement for Planning Optimization is an LCS enabled high-availability environment, tier 2 or higher (not a OneBox environment), with Dynamics 365 Supply Chain Management version 10.0.7 or later. If you try to install the add-in on a OneBox environment, the installation will not complete
If you currently use the built-in master planning engine, you should start planning your migration to Planning Optimization now. It is important to start the migration process right away because your operations may be impacted when deprecation is enforced. To avoid last-minutes issues when deprecation is enforced, MS strongly encourage to complete the migration before December 1, 2020
To see the Planning Optimization fit analysis result, go to Master planning > Setup > Planning Optimization fit analysis, and then select Run analysis. If the analysis finds any inconsistencies, they are listed on the same page.
To configure whether the Planning Optimization Add-in should be used for master planning, go to Master planning > Setup > Planning Optimization parameters
Additional features for planning optimization to enable are
*This post is locked for comments