Quality order process - Partial pass and fail case

(5) Share

Report

Posted on by Yunus

128

Hello,

I'm trying to achieve a scenario, where my PO has a line item of 10 quantity for which the system has created the quality order. Out of 10 i want to move 7 qty to Pass and inventory status to be updated as AVAILABLE and the remaining 3 qty to Fail with a status of BLOCKING.

Even if the full quality order has been failed also, status did not updated to BLOCKING.

Note: WMS enabled warehouse, where mobile device are not used for quality process.

Setup:

Categories:

Dynamics 365 Supply Chain Management

I have the same question (0)

All responses (2)

Answers (0)

Yunus 128 on at

Like (0)

Report

Quality order process - Partial pass and fail case

Hey Laurens,

Here you go..

Was this reply helpful? Yes No
Laurens vd Tang 3,359 Super User 2025 Season 2 on at

Like (1)

Report

Quality order process - Partial pass and fail case

Hello Yunus,

Can you share the setup of the quality association?

Best regards,

Laurens van der Tang

Was this reply helpful? Yes No