Supply chain | Supply Chain Management, Commerce

Mobile Detour Configuration – Missing “Paste in Delete Containers” Option in Entity

(1) Share

Report

Posted on by Kenneth Baeckman

Hi
I’m setting up the mobile detour to delete containers. The configuration works as expected in Entity A. However, when I configure the same detour in Entity B, the option to select "ContainerID" in “Paste in Delete Containers” is not available.
I’ve used the same lookup table and fields in both scenarios. Could you please advise what might be causing the discrepancy in Entity B?

Categories:

Dynamics 365 Supply Chain Management

I have the same question (0)

All responses (3)

Answers (0)

Suggested answer

Laurens vd Tang 4,077 Super User 2025 Season 2 on at

Like (0)

Report
Copy link

Link copied!

Good day,

Can you execute the following actions in entity B?

1. Click on "Create default setup" in the form "Mobile device steps" (might take a few minutes)

2. Click on "Default setup" in the form "Warehouse app field priority"?

3. Click on "Create default setup" in the form "Mobile device steps"?

After the execution of the above actions, can you try it again?

Best regards,

Laurens van der Tang

Was this reply helpful? Yes No
Kenneth Baeckman 4 on at

Like (0)

Report
Copy link

Link copied!

Hi

Thanks for your respons , but unfortunately i still seem to have the issue.

Was this reply helpful? Yes No
Suggested answer

Sagar Suman 6,589 Super User 2025 Season 2 on at

Like (0)

Report
Copy link

Link copied!

Hi

Make sure you are attaching the mobile menu "Delete container' to the right step Id which is as below

If issue still persist check the table which you have attached to the detour. The connection of the "Delete container' mobile menu and the step iD should be accorate.

Was this reply helpful? Yes No