"Put" location directive for Raw material picking

(0) Share

Report

Posted on by KT-19081403-0

I am looking for help around "Put" location for RM picking work.

We have a scenario where few items need to be put on a Location "C"

However, it is understood that, the put location for RM picking work always follow Resource/resource group input location (A) and warehouse default production input location (B) as fallback staging location when resource/group input location is empty.

When I configure Put location directive specifying the put location (added query by specifying items), it still takes put location from either warehouse or resource/group input location.

I suppose the Put location directive overrides both Warehouse default prod input location and resource/group input location ?

Categories:

Dynamics 365 Supply Chain Management

I have the same question (0)

All responses (1)

Answers (0)

CA Vijay Krishna 29 on at

Like (0)

Report

"Put" location directive for Raw material picking

By standard D365 behavior, Put location directives do not override resource/warehouse defaults for RM picking work. The supported route is to use Production input location policies for item-based control.

Can we have snippet of the same if possible for better answer.

Work Around Solution: Please check on the if you are using earlier Version of AX2012 R3

Production Input Location Policies

Under Warehouse management > Setup > Production control > Production input location policies, you can define rules by item or product group to direct RM put locations differently. This is often the supported way to override default staging behavior.

Was this reply helpful? Yes No