You’re offline. This is a read only version of the page.
247
Hello !
In the Item workflow, 1 have 2 approver and the condition is require 1 approver needed.
I created the workflow group user for Approver A (Sequence 1) and Approver B (Sequence 1).
On the Approval Entries, created 2 line for Approver A and Approver B both in Sequence 1.
After Approver A has been approved, Approval B still pending for approval.
I would like to show the result if Approval A has been approved then Approval B approval is not required.
The following are my workflow setup, seem somewhere doesn't setup correct ? Your advice is very much appreciated.
Hi Weiching! :-)
I think you can do something like this:
Remove the "An approval request is approved" event with On Condition = "Pending Approvals >0" because it does not make sense in your side for this example, as with just 1 approver it should be okey.
Add a new Response under "An approval request is approved" with On Condition = "Pending Approvals = 1" (modify to 1, as it's enough to complete the workflow as soon as 1 of your 2 approvers approve it, right?) as follows:
This "Approve the approval request for the record" will auto-approve the remaining Request to approve for the approver that didn't make the action yet.
Of course the restriction will be removed as well as soon as 1 of the 2 approvers approves the request.
I think like this it should work. Check it and let me know.
I hope it helps!,
Vanessa.
#1
Sohail Ahmed
2,678
Super User 2025 Season 2
#2
Sumit Singh
2,635
#3
Jeffrey Bulanadi
2,210
Share
Report
All responses (
Answers (
