web
You’re offline. This is a read only version of the page.
close
Skip to main content
Community site session details

Community site session details

Session Id :
Dynamics 365 Community / Forums / Microsoft Dynamics GP (Archived) / "no symbols have ...
Microsoft Dynamics GP (Archived)

"no symbols have been loaded for this document" while debug GP

(0) ShareShare
ReportReport
Posted on by Reconcile 280

hi

Kindly support me in debugging GP  as i created GPAddin dll using VS 2008 and when i try to debug it and putting Break point it raise  "no symbols have been loaded for this document"

and i need to debug urgent as it takes long time to run application and get values in message

your feedback is highly appreciated

*This post is locked for comments

I have the same question (0)
  • Naga Kiran Profile Picture
    Naga Kiran on at
    RE: "no symbols have been loaded for this document" while debug GP

    Hi Mona,

    The GP Addin should be referring to the latest Product DLL.

    I mean if you have product such as Fixed Assets, the Application.FixedAssets.DLL should be created on top of latest FAM.dic available in the install path. Remove the old reference of Application.FixedAssets.DLL in your Addin project and refer to latest one you built. Rebuild entire project and place the Addin DLL in the Addins folder of your GP install.

    In Short, Application.<Product>.dll and <Product>.dic should be of same version. And you should build your GP Addin based on the latest  Application.<Product>.dll

    Hope this helps.

  • Reconcile Profile Picture
    Reconcile 280 on at
    RE: "no symbols have been loaded for this document" while debug GP

    hi Naga

    thank you for your respond

    i actually refer to the same dll of the products "from the installation path of Dynamics"

    as for Dynamics.dll , it is referenced from location of GP installation folder

    tell what shall i do??

    thx in advance

  • Reconcile Profile Picture
    Reconcile 280 on at
    RE: "no symbols have been loaded for this document" while debug GP

    another point

    when i attach to process "dynamics.exe" it shows on module window "cannot find or open PDB file"

  • Suggested answer
    Naga Kiran Profile Picture
    Naga Kiran on at
    RE: "no symbols have been loaded for this document" while debug GP

    Hi Mona,

    Please check if the setting Generate Debug Info is Yes which under Project Propeties > Configuration Properties > Linker > Debugging tab. If not, try to change it to Yes, Rebuild the Project.

  • Reconcile Profile Picture
    Reconcile 280 on at
    RE: "no symbols have been loaded for this document" while debug GP

    Generate Debug Info=include none,full, PDB only

    and i tried them all with no sucess

Under review

Thank you for your reply! To ensure a great experience for everyone, your content is awaiting approval by our Community Managers. Please check back later.

Helpful resources

Quick Links

Responsible AI policies

As AI tools become more common, we’re introducing a Responsible AI Use…

Abhilash Warrier – Community Spotlight

We are honored to recognize Abhilash Warrier as our Community Spotlight honoree for…

Congratulations to the September Top 10 Community Leaders!

These are the community rock stars!

Leaderboard > 🔒一 Microsoft Dynamics GP (Archived)

Last 30 days Overall leaderboard

Featured topics

Product updates

Dynamics 365 release plans