Testing MRP and MPS

(1) Share

Report

Posted on by JE-20081519-0

3,238

Hi:

In Business Central for a Production environment, what are some good "examples" for testing MRP and MPS and to ensure that the Planning elements such as reorder points and reorder policies are performing well and producing accurate results?

Thanks!

John

Categories:

Dynamics 365 Business Central

I have the same question (0)

All responses (3)

Answers (1)

Suggested answer

PRao 394 on at

Like (1)

Report

Try with Stockkeeping unit where you can setup planning parameter and then run the MRP and MPS planning worksheet if you did not try that .

Also run the planning worksheet after changing the Manufacturing policy. You may also check at Production BOM side how component item is get calculated based on sales demand of production item.

Refer below learning path

https://learn.microsoft.com/en-us/dynamics365/business-central/design-details-supply-planning
https://learn.microsoft.com/en-us/dynamics365/business-central/production-planning

Thanks,
PRao

Was this reply helpful? Yes No
Suggested answer

Khushbu Rajvi. 20,647 Super User 2025 Season 2 on at

Like (2)

Report

Hope this helps as well: https://www.youtube.com/watch?v=tAWqR3bXOTk

https://learn.microsoft.com/en-us/dynamics365/business-central/production-how-to-run-mps-and-mrp

https://www.youtube.com/watch?v=V_BtFvtlqbM

Was this reply helpful? Yes No
Verified answer

Ben Baxter 6,620 Super User 2025 Season 2 on at

Like (0)

Report

The only person that can tell if your suggestions are accurate and in line with the business is your planner (assuming they are good at their job). They should be able to look at the current supply/demand for an Item and say what they would do. You then run planning and see if you get that result, again assuming you want to plan how the existing planner does it.

Everything should be tested and adjusted in a Sandbox first. Only after the results have been verified, and the process flow approved by the team, should the parameters be enabled in the Production Environment. The use of Config. Packages makes moving the MRP setup selections to Production very easy.

Best Regards,

Ben Baxter

Accent Software Inc

Was this reply helpful? Yes No

Join the conversation

Community site session details

Testing MRP and MPS

Helpful resources

Quick Links

Responsible AI policies

Neeraj Kumar – Community Spotlight

Congratulations to the November Top 10 Community Leaders!

Leaderboard > Small and medium business | Business Central, NAV, RMS

Featured topics

Product updates

Community site session details

Testing MRP and MPS

Helpful resources

Quick Links

Responsible AI policies

Neeraj Kumar – Community Spotlight

Congratulations to the November Top 10 Community Leaders!

Subscribe to this forum!

Select categories

Leaderboard > Small and medium business | Business Central, NAV, RMS

Featured topics

Product updates