Item tracking issue

(0) Share

Report

Posted on by crisie

Hello all,
I am working with production orders and I have a problem during item tracking lots of raw materials consumption in production journal.
For Example I have a production order that produces 100 pieces in 2 lots (output LOT1 of 40 pieces and LOT2 of 60 pieces)
The first lot LOT1 uses a component that has MP1 lot while LOT2 uses the same component with MP2 lot.
When I use the page 'item tracking' to analyze the origin of LOT1, the system displays both lots MP1 and MP2. Same thing if I check LOT2.
Is there a way to link consumption of lot MP1 to output LOT1 and the Consumption of lot MP2 to output lot LOT2?

Thanks in advance

I have the same question (0)

All responses (2)

Answers (1)

Verified answer

Community Member on at

Like (1)

Report
Copy link

Link copied!

Crisie,

I took your example and it is possible if I enter my Output and Consumption, on the Production Journal, by Lot creation. Here are some images:

Item Tracing:

Drill into the ILE Lines to see how my Output Lot points to the Consumption Lot:

You should try this in your Sandbox as a test. It will produce the results you expect.

Hope this helps.

Thanks,

Steve

Was this reply helpful? Yes No
crisie 5 on at

Like (0)

Report
Copy link

Link copied!

Hi Steve,

I would have preferred to use only 'item traking' to verify the lots traceability without drilling into ILE

Thank you for your answer.

crisie

Was this reply helpful? Yes No