web
You’re offline. This is a read only version of the page.
close
Skip to main content

Announcements

No record found.

News and Announcements icon
Community site session details

Community site session details

Session Id :
Dynamics 365 Community / Forums / Supply chain | Supply Chain Management, Commerce / Confirming shipment in...
Supply chain | Supply Chain Management, Commerce
Suggested Answer

Confirming shipment in inbound load with TMS route

(1) ShareShare
ReportReport
Posted on by dyncon365 17

Hi All, 

I have a strange problem with confirming shipment in load direction inbound I'm getting a message
pastedimage1673445475566v1.png

My scenario is:

1. Create purchase to WMS warehouse order with product turned on warehouse management processes.

2. Adding line to new load by load planning workbench.

3. Next I am using rate route workbench-> route with rate-> assign route (I also try to use manual rating).

4. Confirm inbound shipment

I can only confirm load only when I don't have any route assigned to load or I use shipping carrier with the blank setting "Activate carrier rating". In that way, my route has the status "none" and I don't have any Miscellaneous charges on PO line. Is it rating profiles in carrier setting necessary to use a simple route with rate? I also try to use shipping carrier with rating profile and I got the same issue. 

I have the same question (0)
  • Suggested answer
    huijij Profile Picture
    huijij 19,813 on at

    Hi dyncon365,

    The load or shipment is currently in a state where shipment confirmation fails. Before you can confirm the shipment, at least some work must exist for the load, and all that work must have a status of Closed or Canceled.

  • dyncon365 Profile Picture
    dyncon365 17 on at

    Hi Judy,

    Are you sure? It's inbound load not outbound. Before I always confirmed shipment from load before receiving process and load has status shipped.

    learn.microsoft.com/.../inbound-load-handling

    "When the vendor dispatches the load, the logistics coordinator at the receiving warehouse confirms the load shipment. "

  • Suggested answer
    Mohamed Mekkawy Profile Picture
    Mohamed Mekkawy 3 on at

    I also encountered this error message during an outbound load confirmation. As we utilize TMS without WMS, my specific case may be different, but this solution may be helpful.

    After receiving the error message, I discovered that one of the route segments was not properly associated with a load. Specifically, the final segment had zero loads configured.

    The solution was to properly configure my load so that its destination matched the route's final segment. By doing this, the last segment now had a load, and I was able to successfully confirm the outbound shipment.

     

Under review

Thank you for your reply! To ensure a great experience for everyone, your content is awaiting approval by our Community Managers. Please check back later.

Helpful resources

Quick Links

Introducing the 2026 Season 1 community Super Users

Congratulations to our 2026 Super Stars!

Meet the Microsoft Dynamics 365 Contact Center Champions

We are thrilled to have these Champions in our Community!

Congratulations to the April Top 10 Community Leaders

These are the community rock stars!

Leaderboard > Supply chain | Supply Chain Management, Commerce

#1
André Arnaud de Calavon Profile Picture

André Arnaud de Cal... 164 Super User 2026 Season 1

#2
Laurens vd Tang Profile Picture

Laurens vd Tang 106 Super User 2026 Season 1

#3
Zain Mehmood Profile Picture

Zain Mehmood 89 Most Valuable Professional

Last 30 days Overall leaderboard

Featured topics

Quality order uses default receipt location instead of actual physical receipt location

Product updates

Dynamics 365 release plans