What to pass for Bin_XFer_Doc_Number parameter ?

(0) Share

Report

Posted on by Community Member

Hi, I would like to develop a bin transfer module using econnect. I will go with taIVMultibinBinToBinTransfer node however, I don't now what parameter I should pass for Bin_XFer_Doc_Number string. The documentation also does not say anything about that parameter (https://msdn.microsoft.com/en-us/library/ff623662.aspx)

I think it should be a unique number however if it is, shouldn't the gp assign this by itself?

Sincerely,
Ahmet

*This post is locked for comments

I have the same question (0)

All responses (1)

Answers (0)

Suggested answer

Angel Nuñez on at

Like (0)

Report
Copy link

Link copied!

I think you need to define a rolling column to use the next Bin Transfer number from the IV setup.

Was this reply helpful? Yes No