You’re offline. This is a read only version of the page.
Hi everyone,
I seem to have encountered a problem where report writer isn't pulling the company name, for example, on a PO.
It does however pull the two following address lines.
The Location name field is set to data and the same settings are working in a separate company just fine.
We looked at the SY00600 table and it returns two lines of data, do we need to delete one? is the problem because the program can't choose between the two so it displays nothing?
*This post is locked for comments
I have the same question (0)Hi,
First, is this a modified report? I'm guessing it is. If it is, the problem is in the report writer layout. The address block calculated fields were changed in version 2013, many of my modified reports needed to be changed because it threw the address block off. You didn't say which address is wrong - the ship to address comes from the header of the PO; the bill to address comes from the Vendor Address Master. As far as report writer being confused and just printing nothing, that will not happen. Take a look at the report layout and the calculated field definitions of the address block fields.
Kind regards,
Leslie
Share
Report
All responses (
Answers (
65,271
