Error: You may not enter numbers manually. If you want to enter numbers manually, please activate Manual Nos. in No. Series ITEM-CH.

(0) Share

Report

Posted on by joshtechsolutions

4,979

Hi Community,

I'm doing Configuration package for a list of items with the SKU IMP001-999from one company, and now I'm moving to the new company, but when I run, Navision gives me this error.

You may not enter numbers manually. If you want to enter numbers manually, please activate Manual Nos. in No. Series ITEM-CH.

In my number series, actually, I already have SKU-IMP set up for this IMP series... how can I direct Navision to accept SKU-IMP instead of using Item-CH?

Thank you.

I have the same question (0)

All responses (4)

Answers (0)

Suggested answer

Nitin Verma 21,708 Moderator on at

Like (0)

Report

Hi Josh,

Just go the No. Series Page of that Code and tick the Manual Nos. columns as per below image, and then try again.

Was this reply helpful? Yes No
joshtechsolutions 4,979 on at

Like (0)

Report

Hi Nitin,

I think you missed reading my later part.

In my number series, actually, I already have SKU-IMP set up for this IMP series... how can I direct Navision to accept SKU-IMP instead of using Item-CH?

Thank you!

Was this reply helpful? Yes No
Suggested answer

Nitin Verma 21,708 Moderator on at

Like (1)

Report

Ok, In new company can you check how many no. series code available, you can put the required code in the Inventory setup > Item Nos. field and then have to select Default Nos. in No. series page against that code and put a check mark.

Please let me know if it works.

Thanks.

Was this reply helpful? Yes No
joshtechsolutions 4,979 on at

Like (0)

Report

Ah Bravo! Found it! Thanks Nitin!

Was this reply helpful? Yes No