web
You’re offline. This is a read only version of the page.
close
Skip to main content

Notifications

Announcements

No record found.

News and Announcements icon
Community site session details

Community site session details

Session Id :
Dynamics 365 Community / Forums / Microsoft Dynamics GP (Archived) / eConnect 10 code sampl...
Microsoft Dynamics GP (Archived)

eConnect 10 code samples C# .NET

(0) ShareShare
ReportReport
Posted on by Community Member

Hello,

I'm hoping to locate code samples for eConnect 10. Through my research I've learned that upon installation the code samples should drop in the following path,

C:\Program Files (x86)\CommontFiles\Microsoft Shared\eConnect 10

I've also found other variations of this path within these forums, however, I've had no luck in locating them. I've just began working with eConnect and it was previously installed on the machine, so it's possible the the 'Help and Samples' were not installed along with eConnect from the start.

Is there a way to locate samples online somewhere? My objective is to load new vendors into GP. Thanks.

*This post is locked for comments

I have the same question (0)
  • Suggested answer
    Tom Cruse Profile Picture
    Tom Cruse 1,477 on at

    We're running eConnect 12, I'm not if the path has changed since this release but this is where our code samples are located

    C:\Program Files (x86)\Microsoft Dynamics\eConnect 12.0\eConnect Samples

  • Community Member Profile Picture
    Community Member on at

    Hi, thanks for your reply.

    I think I've exhausted all possibly paths in my directories where these files could be located. Being that I'm currently running an older version of eConnect, I believe it's possible that the 'Help and Samples' portion was not automatically installed - and whoever did the eConnect installation on my end did not bother to go the extra step and install it.

    If a GP rep could confirm that 'Help and Samples' would not automatically be installed with an eConnect 10 installation, this could provide more insight.

    At this point I'd like to look past this and find out whether I can access these files from another source - perhaps online? Thanks again.

  • Suggested answer
    Tom Cruse Profile Picture
    Tom Cruse 1,477 on at

    Do you have the install disk for GP? I'm not sure how the additional products are listed when you run the general setup but for 2013 when you run the setup one of the components you can install is eConnect. The Help and Samples is a feature you can select during this piece of the install.

  • Community Member Profile Picture
    Community Member on at

    Yeah unfortunately eConnect/GP was installed for my company years ago by a third party and I do not have the install disk at this time.

Under review

Thank you for your reply! To ensure a great experience for everyone, your content is awaiting approval by our Community Managers. Please check back later.

Helpful resources

Quick Links

Responsible AI policies

As AI tools become more common, we’re introducing a Responsible AI Use…

Neeraj Kumar – Community Spotlight

We are honored to recognize Neeraj Kumar as our Community Spotlight honoree for…

Congratulations to the November Top 10 Community Leaders!

These are the community rock stars!

Leaderboard > 🔒一 Microsoft Dynamics GP (Archived)

#1
Community Member Profile Picture

Community Member 2

#2
mtabor Profile Picture

mtabor 1

#2
Victoria Yudin Profile Picture

Victoria Yudin 1

Last 30 days Overall leaderboard

Featured topics

Product updates

Dynamics 365 release plans