Production order - balance left in Estimated manufacturing cost absorbed

(3) Share

Report

Posted on by LIN LIN

Hi Expert,

We get the production order senerio, that the amount is not fully offset when we end the production order.

Normally when we post the routing card the amount will register credit in 'Estimated manufacturing cost absorbed'

Then when you end the production order, fully offset will be posted debit in 'Estimated manufacturing cost absorbed'

I assume that's the normal process. But we get the senerio when we end the production order, the offset debit amount is lower then the credit amount in 'Estimated manufacturing cost absorbed' . Is that the route card posted but not involved when we end the production order? Is this process normal?

Best Regards,

LIN

Categories:

Dynamics 365 Supply Chain Management

I have the same question (0)