Warehouse Management Enabled - Cannot Add Location when Adjusting Inventory

(0) Share

Report

Posted on by Community member

Good Day Dynamics Community,

I am using D365 with Advanced Warehouse (WMS enabled in USMF environment) and when trying to adjust inventory, I cannot add the location; it is greyed out.

Everything is configured correctly to the best of my knowledge; I am using 'Zones' and 'Zone IDs'.

Hope someone can help me find out what I am missing with this setup.

Thanks in advance!

Kind Regards,

Kristi

I have the same question (0)

All responses (2)

Answers (0)

Suggested answer

Gaurav Bharti 145 on at

Like (0)

Report

Warehouse Management Enabled - Cannot Add Location when Adjusting Inventory

Hi kristi,

few things to check:

Warehouse you are adjusting inventory is WMS Enabled:

Then Check Storage Dimension group used is WMS Enabled with Location, Inventory status and Licence plate also Active:

lastly ensure the item which you are adjusting have this Storage dimension group attached

If these setups are correct, you will be able to see location also enabled

Was this reply helpful? Yes No
Suggested answer

Fasih 416 on at

Like (0)

Report

Warehouse Management Enabled - Cannot Add Location when Adjusting Inventory

HI,

Create a storage dimension and active the location of storage dimension, assign it on product and then try.

Was this reply helpful? Yes No