When rendering a report to a PDF, the logo is pixelated and blurry. It looks fine when rendering to Word. Can someone help with this?

(0) Share

Report

Posted on by Community Member

When rendering a report to a PDF, the logo is pixelated and blurry. It looks fine when rendering to Word. Can someone help with this? I've tried adjusting the image size, exporting it with high and low resolution. I'm not sure what else to do.

Thanks!

*This post is locked for comments

I have the same question (0)

All responses (5)

Answers (0)

Community Member on at

Like (0)

Report
Copy link

Link copied!

What format is your logo in?

Was this reply helpful? Yes No
Community Member on at

Like (0)

Report
Copy link

Link copied!

I've tried JPEG and PNG.

Was this reply helpful? Yes No
Suggested answer

Adrian Begovich 1,027 Moderator on at

Like (0)

Report
Copy link

Link copied!
Hi CHARB,

Open the report in SSRS, and check these settings.

Check the property on Image size in SSRS and set image size to Fit proportional if it is not already set to this.

On the Report properties set Preview Mode to Print Layout.

After these settings are changed, attempt to export the report to PDF again.

Was this reply helpful? Yes No
Suggested answer

Community Member on at

Like (0)

Report
Copy link

Link copied!

Hello CHARB

you can fix the size of the image from properties.

Was this reply helpful? Yes No
Suggested answer

Community Member on at

Like (0)

Report
Copy link

Link copied!

Hi Charb,

Try to size the image to the proper number of inches based on 96 DPI calculations. Then use Bitmap.SetResolution to set the images to at least 300 DPI. That may provide a higher quality image that is the proper number of pixels to fit properly in the report

Thank You

Was this reply helpful? Yes No