Supply chain | Supply Chain Management, Commerce

Fulfillment policy on sales order

(2) Share

Report

Posted on by CU13032032-0

213

Hi, If a sales order header has 100% fulfillment policy and I have two lines. Line 1 has order quantity is 10 and all of it is available, line 2 has order quantity as 5 and only partial is available. I want to go to the outbound work bench and add line one to a load and release it. Is there a way to release a single line from this screen if the fulfillment policy on the header is still set to 100%

Categories:

Dynamics 365 Supply Chain Management

I have the same question (0)

All responses (3)

Answers (0)

Sort by

Suggested answer

Laurens vd Tang 4,853 Super User 2026 Season 1 on at

Like (0)

Report
Copy link

Link copied!

Good day,

That should be possible. You can select one line and click on "To new load"

Best regards,

Laurens van der Tang

Was this reply helpful? Yes No
CU13032032-0 213 on at

Like (0)

Report
Copy link

Link copied!

Hi, I tried to do this but I am still getting error (when I click Release to Warehouse) for 100% fulfillment which is on the header level. I have to change the fulfillment policy on header to release the load. Am I missing any setup? @Laurens vd Tang

Was this reply helpful? Yes No
Suggested answer

Laurens vd Tang 4,853 Super User 2026 Season 1 on at

Like (0)

Report
Copy link

Link copied!

Good day,

I checked it again, but I think it is unfortunately not possible to release one line, because the Fullfillment policy is on sales order header level

Best regards,

Laurens van der Tang

Was this reply helpful? Yes No