Small and medium business | Business Central, N...

allocated location - Permission Set

(1) Share

Report

Posted on by MH-18052024-0

hello All

I have a problem with the issue of permissions and setting a filter on the use of sites
When I put more than one filter in the same table, an error message appears and I am unable to complete the process

Categories:

Dynamics 365 Business Central

I have the same question (0)

All responses (6)

Answers (0)

Suggested answer

Nitin Verma 21,698 Moderator on at

Like (0)

Report

Hi,

I am not facing this error, did you check if there is development done on this area?

Thanks

Nitin

Was this reply helpful? Yes No
Suggested answer

Jun Wang 8,200 Super User 2025 Season 2 on at

Like (1)

Report

I would suggest you to add one filter at a time to see what is causing the issue. And in transit location is only used to track inventory in transit, so that filter might not be needed.

Was this reply helpful? Yes No
Suggested answer

tanya07 1,638 on at

Like (0)

Report

Hi,

What does the error say ?

BR,

Tanya

Was this reply helpful? Yes No
Suggested answer

HVGEEL 308 on at

Like (0)

Report
Have you tried the standard functionality of Transfer Routes?

- Set the required combinations in the Transfer Route Page

FROM Location

TO location

In-transit location

Shipping agent

Shipping Agent Service

If this is not the answer to your question... please elaborate.

Was this reply helpful? Yes No
Suggested answer

YUN ZHU 95,329 Super User 2025 Season 2 on at

Like (0)

Report

Hi, It looks like you set up the Security Filter using Include type.

This means that you can only see those that meet all of these conditions.

If you ask a user with permission to enter these three values, and then open it again, it should be no problem. However, during the input process, you do not have permission to see the null value, so this error occurs.

I think you can try the following settings.

Hope this helps.

Thanks.
ZHU

Was this reply helpful? Yes No
MH-18052024-0 20 on at

Like (0)

Report

thank you all

Unfortunately... I tried all the suggested solutions, but the problem still exists
To clarify more :
When I put one filter, it works correctly, but when I add another filter, the problem in the picture appears

Was this reply helpful? Yes No