Dynamics 365 CommunityForums Microsoft Dynamics RMS (Archived) RMS Net Display Channe...

RMS Net Display Channel not switching according to define time

(0) Share

Report

Posted on by Community Member Microsoft Employee

Hi,

We are on RMS 2.0.0113. I have setup 2 local Net display channels which need to be rotate on define seconds but it doesn't switch to next one according to seconds i input on properties.

Individually both works fine if its in Top.

*This post is locked for comments

All responses (2)

Answers (0)

Community Member Microsoft Employee on at

Like (0)

Report

Re: RMS Net Display Channel not switching according to define time

HI Akbar,

Thank you for your response. I m aware its not HTTP. We are using local net display channels since Internet not allowed in POS terminal. Local links are supported as well. but only thin it dosen't switch to next channel.

Regards
Alwani 710 on at

Like (0)

Report

Re: RMS Net Display Channel not switching according to define time

hi dear, the URL should be in form of HTTP:\\xxxx

URL: The address of the Web site or file to be displayed.

Make sure C:\ drive is not web URL. Check the documentation