Supply chain | Supply Chain Management, Commerce

Where can I setup variant number sequence

(0) Share

Report

Posted on by Marco_Meinders

Hello,

I want to use product variants for engineering products. At the moment I want to create variants I get the error message: Variant number sequence is not set.
Where can I setup this number sequence?

In an older forum topic I saw it should be in Retail Module, however I do not find it there (anymore).

Thanks for responding.

Regards,

Marco

I have the same question (0)

All responses (2)

Answers (0)

Suggested answer

André Arnaud de Cal... 303,560 Super User 2026 Season 1 on at

Like (0)

Report
Copy link

Link copied!

Hi Marco,

If you go to the Commerce parameters form (Retail and commerce > Headquarters setup > Parameters), you will find the Variant number sequence. If this is still not visible, you can run the number sequence wizard which will suggest creating number sequences for references you didn't set up yet. You can then remove all other references and have a default number sequence added to this reference.

Was this reply helpful? Yes No
Suggested answer

Mohamed GRAIB 2,504 Moderator on at

Like (2)

Report
Copy link

Link copied!

Hi Marco_Meinders,

Just follow these steps,

navigate to Retail & commerce > headquarters setup >commerce parameters

Step 2 : Navigate to number sequence parameters

Hope that's helpful for you

Please mark the answer as verified if that's resolve your problem.

Best regards,

Mohamed GRAIB

2 people found this reply helpful.

Was this reply helpful? Yes No