Small and medium business | Business Central, N...

Dimension value - code mandatory

(0) Share

Report

Posted on by Nirmala Karunarathna

277

Even though the dimension values are defined in the assembly, the system keeps asking to select a dimension code.

I could not figure out what is the reason. I removed the dimension and re-entered again. Still the same issue.
Account 59200 - inventory adjustment account - (setup with code mandatory for dimension cost centre in G/L card)

Any suggestion ?

I have the same question (0)

All responses (4)

Answers (0)

Suggested answer

Community Member on at

Like (0)

Report

Nirmala,

The message does comes from the GL Account mandating the Dimension Code COST CENTRE. Now, for the Finished Assembled Item and Components, each of the Items has a COST CENTRE Dimension Code, yes? Also, in Assembly, you could have Resource so please check if that has a COST CENTRE Dimension Code set.

Thanks,

Steve

Was this reply helpful? Yes No
Nirmala Karunarathna 277 on at

Like (0)

Report

Yes, there are resource lines. Those are having cost centres assigned.

Was this reply helpful? Yes No
Suggested answer

YUN ZHU 95,679 Super User 2025 Season 2 on at

Like (0)

Report

Hi, this seems to be that you added the dimension to the master data (G/L Account 59200), but it is not applied to this document.

Is the dimension added after the document is created? If so, please delete the document and create a new one, which should solve the problem.

Hope this will help.

Thanks

ZHU

Was this reply helpful? Yes No
Nirmala Karunarathna 277 on at

Like (0)

Report

No dimension mandatory has been setup initially, not after the document creation.

Was this reply helpful? Yes No