You’re offline. This is a read only version of the page.
107
Hi
I am doing an upgrade of GP from version 2010 to GP2016. I have run GP2016 utilities and I get an error message as follows:
The description for Event ID 0 from source Microsoft Dexterity cannot be found. Either the component that raises this event is not installed on your local computer or the installation is corrupted. You can install or repair the component on the local computer.
If the event originated on another computer, the display information had to be saved with the event.
The following information was included with the event:
An exception occurred while trying to load or initialize the addin located at OnlineServices.
Exception Details:
System.IO.FileNotFoundException: Could not load file or assembly 'Microsoft.Dynamics.GP.OnlineServices, Version=16.0.0.0, Culture=neutral, PublicKeyToken=31bf3856ad364e35' or one of its dependencies. The system cannot find the file specified.
File name: 'Microsoft.Dynamics.GP.OnlineServices, Version=16.0.0.0, Culture=neutral, PublicKeyToken=31bf3856ad364e35'
at System.RuntimeTypeHandle.GetTypeByName(String name, Boolean throwOnError, Boolean ignoreCase, Boolean reflectionOnly, StackCrawlMarkHandle stackMark, IntPtr pPrivHostBinder, Boolean loadTypeFromPartialName, ObjectHandleOnStack type)
at System.RuntimeTypeHandle.GetTypeByName(String name, Boolean throwOnError, Boolean ignoreCase, Boolean reflectionOnly, StackCrawlMark& stackMark, IntPtr pPrivHostBinder, Boolean loadTypeFromPartialName)
at System.RuntimeType.GetType(String typeName, Boolean throwOnError, Boolean ignoreCase, Boolean reflectionOnly, StackCrawlMark& stackMark)
at System.Type.GetType(String typeName, Boolean throwOnError)
at Microsoft.Dexterity.Bridge.AddinManager.LoadAddinsFromConfig(String configPath, String sectionName)
WRN: Assembly binding logging is turned OFF.
To enable assembly bind failure logging, set the registry value [HKLM\Software\Microsoft\Fusion!EnableLog] (DWORD) to 1.
Note: There is some performance penalty associated with assembly bind failure logging.
To turn this feature off, remove the registry value [HKLM\Software\Microsoft\Fusion!EnableLog].
the message resource is present but the message is not found in the string/message table
Your assistance will be greatly appreciated.
Regards
Patience
*This post is locked for comments
I have the same question (0)
#1
Community Member
2
#1
babubaskaran@outloo...
2
#1
Yng Lih
2
Share
Report
All responses (
Answers (