385
I am unsure if this is actually a Dynamics question.
When I try to input a work order, take out the inventory used, there is a column that reports no available inventory. However, this inventory is there under an allocation column. The inventory is also present when I do a cycle count.
How can I get the inventory into "Available" so I can finish the input of the work orders ??
*This post is locked for comments
Ok, I will try that. Thank you so much for your help. I was able to solve other issues with your first suggestion.
Yes I did. This is the shot after it ran. Could a simple inventory adjustment correct this problem ??
Based on your screen shot, The inventory item (140110) is not available in your stock.
1. you have put for the 17000 qty receipt for 14110 item.
2. The Item has been issues to kit/BOM assembly (-3580-2317-3954-2190-2994-1965) = (-17000)
Hence your the receipt Qty has been issued fully against the kit/BOM, There is no qty available shown in your inventory.
Did you run the process manager?
Here is a snip of what I am seeing in the Lot/Serial window under inventory status inquiry. We have the 1965 left however, it says Issue. Do you know what that means? I'm assuming this is why I can not pull the inventory back into available.
You have to do the following steps to run IN Integrity check against the Inventory Item.
Hope this explains.
I am learning a lot at once because no one here really knows how to use Dynamics. So I open that window and it wants me to select validate. When I select validate the other options illuminate. How can I rebuild this item to show as available?
Share
Report
All responses (
Answers (
