Manufacturing this is not a valid document for the user

(0) Share

Report

Posted on by Community Member

In the Manufacturing Order Activity window when I double click on the Pick Document I receive the following message. This is not a valid document for the user. Why doesn't it open the pick document? All the other document types open up just fine....MO receipt, IV Transaction, Journal Entry. The user is a Power User, so they should have access to everything.

*This post is locked for comments

I have the same question (0)

All responses (5)

Answers (0)

Sort by

Suggested answer

babubaskaran@outloo... 12 on at

Like (0)

Report
Copy link

Link copied!

Hi,

Please run checklink against Manufacturing inventory and check it again. Please take a backup before doing this.

Was this reply helpful? Yes No
Community Member on at

Like (0)

Report
Copy link

Link copied!

I ran checklinks and the issue still exists. Other ideas?

Was this reply helpful? Yes No
Suggested answer

babubaskaran@outloo... 12 on at

Like (0)

Report
Copy link

Link copied!

Please create a new user with power user role and check this.

Was this reply helpful? Yes No
Suggested answer

Tom Cruse 1,477 on at

Like (0)

Report
Copy link

Link copied!

I would also suggest to look and see if there are any modified custom reports for that module and see which one is selected if there.

Also what about that users security, is there a different Alternate/Modifed Reports selected? Does it work for some users and not others? That might be why.

Was this reply helpful? Yes No
Community Member on at

Like (0)

Report
Copy link

Link copied!

I ran into the same issue and discovered that the user had Binary Stream Multi-Entity installed. The Manufacturing Order did not have an entity assigned. Went through the MEM utilities and assigned it to the proper Entity and the problem went away.

Was this reply helpful? Yes No