Announcements
No record found.
no matter how I change the 'Field Label Width' it's all the same looking like above
*This post is locked for comments
Hi,
can you check if you enable below setting?
www.magnetismsolutions.com/.../introduction-to-a-new-dynamics-365-setting---allow-text-wrapping-in-form-fields-labels-and-values
if yes, try to clear cache.
if No, try to apply it.
It appears that you have set the 4 column formatting which means the layout will try to show 4 column on the same row thus your width may not apply. Try changing the formatting to 2 column and see if it helps. Also see if moving the section to some other tab (with just one section) helps. At the end its about how much horizontal space you have.
You can go for the above suggested workaround of text wrapping if that suits your needs.
Hope this helps.
In addition , have a look below thread where I have mentioned some steps , might be helpful for you -
community.dynamics.com/.../273740
Under review
Thank you for your reply! To ensure a great experience for everyone, your content is awaiting approval by our Community Managers. Please check back later.
Congratulations to our 2026 Super Stars!
We are thrilled to have these Champions in our Community!
These are the community rock stars!
Stay up to date on forum activity by subscribing.
