Flip Switch Fields misbehaviour before flyout in header

(0) Share

Report

Posted on by GiridharRaju

Hi Community,

I have added four field in the header section where two of them are two options field(flip switch control enabled) and other two are lookup fields. I expect all the four fields to be shown before flyout in the header section. Surprisingly I could see only two fields before the flyout i.e those lookup fields. I couldn't see other two flip switches. But I could see all the four fields in the flyout. Kindly help.

Thank You!

S.Giridhar Raju

I have the same question (0)

All responses (2)

Answers (2)

Verified answer

Paul_Owen 2,027 on at

Like (0)

Report

RE: Flip Switch Fields misbehaviour before flyout in header

You can't use controls in the header but I think they will work in the flyout.

Regards

Paul

Was this reply helpful? Yes No
Verified answer

Diana Birkelbach 140 Most Valuable Professional on at

Like (0)

Report

RE: Flip Switch Fields misbehaviour before flyout in header

As Paul Owen said, the components are not shown in a High Density Header. That's specified in the documentation too: docs.microsoft.com/.../form-designer-header-properties

But in the same link it's stated too, that the components are supported/displayed in a Low-Density-Header.

Was this reply helpful? Yes No