You’re offline. This is a read only version of the page.
Hi community,
I am having problems in setting up Datalogic Magellan 8400 .
Is there suppose to be a usb port for Datalogic Magellan 8400 ? I can not locate it .
I was told it is best to use Magellan OSP.
My unit , Magellan 8400 has 2 RS232 Cables one for the Scale ( Com1 ) and one for the Scanner ( Com2).
When I use the DualTest.exe , after changing setting in regedit mode I get reading for the Scale (a weighted item) and Scanner .
When I connect it to The Pos program No Reading for Scale and Scanner shows the number and that is it
How can I set the scanner to read the bar code and added to the system?
regards
*This post is locked for comments
I have the same question (0)
Hello,
Thank you for your question.
If you have not yet, I would recommend contact Magellan for support with the setup, as they would be best to assist you with this issue.
Thank you,
Scott Wardzinski
Microsoft Dynamics RMS & POS Support Engineer
Share
Report
All responses (
Answers (
