10401 Format MICR Business Central

(0) Share

Report

Posted on by tlhgolfer

I am using the check format 10401 and wanting to use the new MICR font feature, but when we print the checks the MICR is too high and it is already a footer and will not allow us to move it down to where it should be on the check? I have tried moving it and shifting borders, but it still prints about an inch from the edge. Does anyone have any suggestions?

Thanks,

Tanya

I have the same question (0)

All responses (4)

Answers (1)

Suggested answer

Community Member on at

Like (0)

Report
Copy link

Link copied!

Tanya,

I normally edit my Custom report via RDLC (Report Builder). See my check image below of 10401.

Hope this helps.

Thanks,

Steve

Was this reply helpful? Yes No
Suggested answer

tlhgolfer 23 on at

Like (0)

Report
Copy link

Link copied!

Crazy enough I just figured this out I knew if I posted it I would figure it out! What I had to do was on the report properties change the bottom margin to 0in and that did the trick! Just in case anyone else needs this.

Was this reply helpful? Yes No
tlhgolfer 23 on at

Like (0)

Report
Copy link

Link copied!

Steve,

Thanks for responding. I was editing it and moving it down, but that is not enough you have to edit the margins on the report.

Hope this helps others!

Was this reply helpful? Yes No
Verified answer

Marco Mels Microsoft Employee on at

Like (0)

Report
Copy link

Link copied!

Thank you for sharing the final outcome. This does help others.

Was this reply helpful? Yes No