Microsoft Dynamics GP has stopped working while deploying chunk

(0) Share

Report

Posted on by Community Member

when i deployed the chunk file in GP2013 SP 1 installation location & launch the GP, results "Microsoft Dynamics GP has stopped working" and GP closes.. Any one face this issue?

What are the possible ways the above error occurs?

*This post is locked for comments

I have the same question (0)

All responses (3)

Answers (2)

Verified answer

Mahmoud Saadi 32,738 on at

Like (0)

Report

RE: Microsoft Dynamics GP has stopped working while deploying chunk

There are absolutely several potential root causes for this error, although, I would mostly retrieve that to corrupted dictionary.

First of all, are you sure the chunk is working properly ? Try deploying the chunk file on a test environment with a clean installation with no customized third party products, and ensure that the code is deployed successfully into GP Folder. If it does happen again, then I may suspect potential error in chunk code.

Check the following reference, Mr. Ian provides a considerable checklist that you could take into consideration;

Microsoft Dynamics GP has stopped working

As for the current workstation on which you have already deployed the chunk, re-install Dynamics GP, and deploy the chunk one more time.

Hope this helps,

Was this reply helpful? Yes No
Verified answer

Richard Whaley 25,195 on at

Like (0)

Report

RE: Microsoft Dynamics GP has stopped working while deploying chunk

Launch GP as Administator. On the start menu, right click on GP and select Run as Administrator

Was this reply helpful? Yes No
Suggested answer

Community Member on at

Like (0)

Report

RE: Microsoft Dynamics GP has stopped working while deploying chunk

Hi Mahmoud,

In Test environment the chunk extracts and working fine..

Was this reply helpful? Yes No