Specify Installation Parameters at the Command Prompt
Views (99)
Hossein.K
6,648
Like
Share
Report
Use the following procedure to run the installation by entering parameters at the
command prompt.
1. Open a Command Prompt window.
2. At the command prompt, type the following information: <Path to
DVD or shared directory>\Setup.exe parameter1="value"parameter2="value". When using multiple parameters, insert a single
space between parameters.
WARNING: If you enter duplicate parameters, Setup will fail silently.
3. After you have listed all parameters, press Enter.
Regards,
Hossein Karimi
command prompt.
1. Open a Command Prompt window.
2. At the command prompt, type the following information: <Path to
DVD or shared directory>\Setup.exe parameter1="value"parameter2="value". When using multiple parameters, insert a single
space between parameters.
WARNING: If you enter duplicate parameters, Setup will fail silently.
3. After you have listed all parameters, press Enter.
Regards,
Hossein Karimi
*This post is locked for comments