Default Slicer Behavior in OOTB Insights Reports

(2) Share

Report

Posted on by Harshita Singh

Hello everyone,

When opening the out-of-the-box (OOTB) Reports in Microsoft Sustainability Manager, it displays data for all facilities by default, even though no facility is selected in the slicer. This can be confusing, as it suggests no data should be shown without an active selection.

Is this the intended behavior? If not, is there a way to configure the dashboard to show data only after a facility is explicitly selected?

Categories:

Sustainability Manager

I have the same question (0)

All responses (1)

Answers (0)

Ivan (Vanya) Kashperuk on at

Like (0)

Report

So that's the difference between a multi-select slicer (Water quantity page) and a single-select slicer (like on Water quality page)

Are you saying you expected the behavior like on Water quality page here?

In Waste reports, it's multi-select in both

Was this reply helpful? Yes No