Dynamics Community Forum Thread Details

Hi Experts,

I'd like to ask for some guidance, for the Unified Product Experience.

I can maintain existing FO Released Product > DV Products information just fine.

The problem is no new Released Product can be created, whether via releasing from Product, or directly create in Released Product.

Details as below:

Error:

1. Cannot release from Product, from error I think because it does not have Default Unit. However the Product form does not have any field to default the unit.

(error in the Open Product Releases page, with error:

Unable to write data to entity products.Writes to EcoResReleasedDistinctProductDVEntity failed with error message Request failed with status code BadRequest and CDS error code : 0x80040265 response message: No default unit set. The product default unit group cannot be defaulted. For integration scenarios (like Dual Write), please make sure that a valid unit ID is mapped to the default unit for this product. The default unit and default unit group columnd are mandatory..for information on troulbleshooting see http://go.microsoft.com/fwlink/?linkid=2244045. Activitiy ID for troubleshooting {redacted}For information on troubleshooting see https://go.microsoft.com/fwlink/?linkid=2244045..)

2. Cannot create directly in the Released Product form. The error indicate that (since it is a new product) the Product Number is missing.

(error in the Released Product page, with error:

Unable to write data to entity products. Writes to EcoResReleasedDistinctProductDVEntity failed with error message Request Failed with status code BadRequest and CDS error code : 0x80040265 resonse message: product must have msdyn_productnumber filled.For information on troubleshooting see https://go.microsoft.com/fwlink/? linkid=2244045. Activity ID for troubleshooting [redacted] For information on troubleshooting see https://go.microsoft.com/fwlink/?linkid=2244045)

Setup:

1. I used the provided Solutions, in other word, I did not map the entities from scratch.

2. following the official https://learn.microsoft.com/en-us/dynamics365/fin-ops-core/dev-itpro/data-entities/dual-write/product-mapping,

I stopped Released Producs V2, and CDS Released Distinct Products, and running the newer DV released distinct products, and DV released products instead, preparing for the price sync.

Questions:

1. Is there any customized mapping to be done, on top of the provided solution mapping? Am I missing something?

2. Is it the same case as Contacts V2 limitation, that to we can only create a new FO Contact from the parent entities (Customer/Vendor > Add Contact). If so where should a new product be created?

Please advice, thank you.

Categories:

Power Platform integration