How do I change the U of M on the item maintenance?

(0) Share

Report

Posted on by Community Member

How do I change the U of M on the item maintenance? See attached.

I told the customer to try the below - but it didn't work for him:

If you're using Extended pricing, it's possible that the "PriceGroup" field of the item master, which I think comes from/is used in the "Standard Pricing" module may be blank, and that's the source of the error message.

Try changing the Price Group of the item in question to something else, then back to the original (the old Windows(tm) trick) and that may reset it to the correct setting. Then change your UoM again and see if you get the error.

*This post is locked for comments

I have the same question (0)

All responses (4)

Answers (0)

Suggested answer

Mahmoud Saadi 32,738 on at

Like (2)

Report

This is simply because the unit of measurement decimals and item decimals should be the same. I have discussed this scenario thoroughly on the following articles:

Change Decimal Places – Inventory Utility

Changing/Modifying Item Unit of Measurement Schedule (UOM)

Your feedback is highly appreciated,

Was this reply helpful? Yes No
Mahmoud Saadi 32,738 on at

Like (0)

Report

WennSoft

Is this resolved ? Your feedback is highly appreciated,

Was this reply helpful? Yes No
Community Member on at

Like (0)

Report

I haven't gotten a response from our customer yet.

Was this reply helpful? Yes No
Romryan on at

Like (0)

Report

Mahmoud M. AlSaadi killed it for me too.I used to go to use sql which can cause problems if one is not meticulous before I read his blog.

Romryan

Was this reply helpful? Yes No