Time and Attendance

(0) Share

Report

Posted on by RYbarra

Time and attendance is not recording the correct times displayed when clocking in and out in Job Card Terminal.

For example. The clock in time of 8:00am is being displayed as the start break time. Start break time in Job Card Terminal displayed as 10:00am which is when the tech started his break. In time and attendance approval, the break start time shows as 8:00am instead of 10:00am.

I have the same question (0)

All responses (2)

Answers (0)

Ravi Kumar Desu 80 on at

Like (0)

Report

Check if the time zones for the clock in user, D365FP approver is causing this issue. User options will have time zone settings(Sys admin--> users)

Was this reply helpful? Yes No
RYbarra 20 on at

Like (0)

Report

Thank you for replying. I found this to be a setup issue. Job card terminal configure job cards>configure job card terminals>general>use the actual time of registration was set to NO. Setting to yes resolved our issue. Thanks again. Robert

Was this reply helpful? Yes No