DIXF-ODBC Source- Copy Data to Target doesn't find the data in staging

(0) Share

Report

Posted on by malioni91

Hi everyone,

I'm importing data from an external table into AX through DIXF-ODbc source. When I run the process manually, both "get staging data" and "Copy data to target" function properly, however, when I run them in batch, the staging works fine, but then the copying to target doesn't happen. It looks like the second step cannot find the data present in staging?! Has anyone experienced this issue before?

Additionally (if it helps), I have attached a post event handler to the execute target step that is triggered after that step runs. When I run the step manually, it works fine, but as you can see in the screenshot below, it doesn't work when it's triggered through the batch process.

Thanks in advance

*This post is locked for comments

I have the same question (0)

All responses (1)

Answers (0)

malioni91 50 on at

Like (0)

Report
Copy link

Link copied!

I removed the code that causes the exception. Yet, it still doesn't insert the records into the target when I run the process in batch (see image below). However, when I run the copy to target manually, it inserts everything as it should. Re-compiled and re-ran the CIL to no avail.

Was this reply helpful? Yes No