You’re offline. This is a read only version of the page.
Announcements
170
We had SL 7.0 FP1 and noticed that using Finish in the SD.200.00 Service Call Entry screen would cause a Error 11500 (see screen shot). Installed SP3 for FP1 and we still get the same error. It does it for any user and it does it running in Standard. I deleted all records from CustomVBA and Custom2 that were associated with SD.200 and ran with Event Code disabled. Still get the error.
*This post is locked for comments
I have the same question (0)
Hello,
Well it looks like you had the right idea when you upgraded to SP3, but we may need to take that a step further to SP4, then there is a hotfix for this issue that will need to be installed.
2750845
You receive Programming Bulletproof Error 11500 in Service Call Entry
mbs.microsoft.com/.../KBDisplay.aspx
It would probably be a good idea to set up a test environment to test this and see if it resolves the issue before actually deploying it into production.
Share
Report
All responses (
Answers (
