Only one production order with multiple lines when use MTO (make to order)

(0) Share

Report

Posted on by Tanya Susan

500

When i use manufacturing policy in item/SKU card as MTO(Make to order) & if i plan multiple level production orders then system (NAV 2009 R2) will plan only one production order with multiple lines.

But same scenario did on NAV 2013,

It planned same thing but deference production orders.

all the parameters set as follows in both versions,

Manufacturing policy of item/SKU cards = MTO
Reorder policy of production items= Order

Any one note that situation? is it improvement in NAV 2013?

*This post is locked for comments

I have the same question (0)

All responses (6)

Answers (1)

Suggested answer

Aleksandar Totovic 16,765 on at

Like (0)

Report

In this case, system will be create only one planned PO with multiple lines. In NAV2013 is the same situation.

"Make-to-Order: Explodes the BOM and creates an additional production order or production order proposal line for each level in the BOM structure where that item's manufacturing policy has also been defined as make-to-order. If you make multilevel production orders, then the manufacturing policy for the parent item and the component items at all levels must be make-to-order."

Was this reply helpful? Yes No
Suggested answer

Tanya Susan 500 on at

Like (0)

Report

Herewith i have attached screen prints of planning worksheet(PW) & SKU list for the items which are in PW.

According to your explanation what may be the my error point ?

Was this reply helpful? Yes No
Verified answer

Aleksandar Totovic 16,765 on at

Like (0)

Report

My wrong:

NAV2013/Make-to-Order: "Explodes the BOM and creates an additional production order or production order proposal line for each level in the BOM structure where that item's manufacturing policy has also been defined as make-to-order."

NAV2009/Make-to-Order: "Explodes the BOM, and creates an additional production order line or production order proposal line for each level in the BOM structure where that item's manufacturing policy has also been defined as make-to-order."

Was this reply helpful? Yes No
Suggested answer

Tanya Susan 500 on at

Like (0)

Report

You mean both versions are same,

If yes,

is there are any parameter setting mistake of my scenario ?

Was this reply helpful? Yes No
Aleksandar Totovic 16,765 on at

Like (0)

Report

Read carefully, there is little difference (yellow marked): order (2013) / order line (2009).

Was this reply helpful? Yes No
Suggested answer

Tanya Susan 500 on at

Like (0)

Report

Yes got it, thanks a lot .

Was this reply helpful? Yes No