Reset PO# Auto-generation

(0) Share

Report

Posted on by Chad Simmons

410

Our system use to generate the next PO number automatically. At some point someone entered a custom PO number and now auto-generation no longer works. Is there a way to reset this so the program will auto-generate correctly again? We now have everyone entering POs through the program instead of hand writing them so we'd like to unify the operation.

*This post is locked for comments

All responses (2)

Answers (1)

Chad Simmons 410 on at

Like (0)

Report

RE: Reset PO# Auto-generation

Thanks for that. I have 2.0.2012. Evidently that works fine now. It did not in the past but we recently upgraded to CU5. I didn't think to try it this way again.
Verified answer

arishi 740 on at

Like (0)

Report

RE: Reset PO# Auto-generation

Hi Chad,

which RMS update version are you at?

I tried on my end (RMS V2.0.2007) even if give a manual PO# the next PO do generate automatically

what happens if you leave PO number field blank?