Override license plate during put

(0) Share

Report

Posted on by Community Member

Why am I not able to toggle the Override license plate during put setting for Mobile device menu item PO Put Away? We're using D365 F&O (Cloud) (Finance + Ops)

I click to turn the setting on but it reverts to off. Oddly, this setting is turned ON in our staging/sandbox environment.

I don't know how to start troubleshooting this one, hopefully someone can assist.

I have the same question (0)

All responses (4)

Answers (2)

Verified answer

Nirmal 35 on at

Like (0)

Report

Hello,

Disable "Group put away" flag and check.

Regards,

Nirmal

Was this reply helpful? Yes No
Suggested answer

Community Member on at

Like (0)

Report

Thank very much Nirmal. This was the solution.

Are you able to tell me or direct me to any documentation to learn more about the differences here?

Was this reply helpful? Yes No
Verified answer

tabarret on at

Like (1)

Report

Hello Joey,

This restriction was actually introduced in 10.0.8 through KB 4524373. Hopefully this helps explain the "why".

Microsoft has evaluated this issue and determined that there is no support for merging target LP on multiple work headers in this case by using the "override target LP during put" in a group put away scenario. These settings were not intended to work in that way, and a fix has been made to block the use of "override target LP during put" if "group put away" is enabled on system grouping and user grouping directed by modes.

fix.lcs.dynamics.com/.../Details

Was this reply helpful? Yes No
Community Member on at

Like (0)

Report

Hey thanks a lot Taylor!

Was this reply helpful? Yes No