Item Unit of Measure - Rounding Up

(1) Share

Report

Posted on by Tris15

488

Hi Everyone

I am facing challenges with how the Item UOM gets converted
In the example below - I have the items Raw-00172 set up to use mm as base UOM and then secondary UOM is LEN, where 1 LEN = 13000mm.

When I run the order planning, the demand was 27000mm, needed Quantity is 2.07 LEN's then - but what do I change so that my Qty. to Order is always a whole number, in this case 3 (it should always round up)

Kind Regards,

Categories:

Dynamics 365 Business Central

I have the same question (0)

All responses (3)

Answers (0)

Sort by

Suggested answer

Nyakinyua 55 on at

Like
a
(0)

Report
Copy link

Link copied!

Have you tried configuring the rounding precision directly in the UOM setup?

Was this reply helpful? Yes No
Tris15 488 on at

Like
a
(0)

Report
Copy link

Link copied!

Yes I have - I did that and the inverse thereof, and still get the same issue

Was this reply helpful? Yes No
Suggested answer

Jun Wang 8,220 Moderator on at

Like
a
(0)

Report
Copy link

Link copied!

You could set the quality rounding precision to be 1 if you only need whole number.

Was this reply helpful? Yes No