Hi all,
New to TMS and WMS. Was trying to create Load for inbound however it doesnt seem to work. Any how, I need to know the comprehensive setup if there's something I could omitted.
I had create auto-load via TMS/WMS parameter. However, when I click Load Workbench ribbon, and Click New Load, and select template, it doesnt show anything.
But when I navigate to WMS, and Click all loads, the Load ID is there but shown as Outbound Direction. Why is this so? Secondly there is no detail or lines in the Load.
*This post is locked for comments
I have the same question (0)