web
You’re offline. This is a read only version of the page.
close
Skip to main content

Notifications

Announcements

No record found.

News and Announcements icon
Community site session details

Community site session details

Session Id :
Dynamics 365 Community / Forums / Supply chain | Supply Chain Management, Commerce / Movement of inventory ...
Supply chain | Supply Chain Management, Commerce
Suggested Answer

Movement of inventory in Warehouse management - Limit

(1) ShareShare
ReportReport
Posted on by Jesús García 572
Greetings! I am having a problem doing an inventory movement job that I don't quite understand.
Within warehouse X, I have two locations, X1 and X2, where I store item Z, to test that it works correctly, I do an inventory movement job to move 100 units from X1 to X2. This is not supposed to be possible as I have set a limit of 50 to X2 from the WHSLocationLimit form, however, when I complete the job, the inventory has moved from X1 to X2 and the latter exceeds the limit amount I set.
 
I have the same question (0)
  • Suggested answer
    Laurens vd Tang Profile Picture
    Laurens vd Tang 4,012 Super User 2025 Season 2 on at
    Hello Jesus,
     
    Are both locations linked to the same location profile? The stock limit works only on location profile level. 
     
    Best regards,
    Laurens van der Tang
  • Jesús García Profile Picture
    Jesús García 572 on at
    Hi Laurens, yes both of Locations are linked to the same location profile level. Nevertheless, i have the same problem: I create a inventory movement Work  with origin X1, destiny X2, i move like 200 UD but at the same time there is a limit in X2: 500 and this location contains 400 UD, so it supposes that it shouldnt move 200 ud to X2, but then, i validate the work and complete it and finally, the location contains 600 UD, exceeding the limit i put.
     
    Best regards.
    Jesús
  • Guy Terry Profile Picture
    Guy Terry 28,924 Moderator on at
    Stocking limits will only ensure that D365 SCM does not suggest to over fill a location (e.g. during Purchase order put away, if you have configured D365 SCM to suggest put away locations). It will not block a user if they choose to over fill a location.
     
    The reason being, if the user says they have put 100 units in to X2 then that needs to be reflected in the system.
  • Jesús García Profile Picture
    Jesús García 572 on at
    Thank you very much, I think I understand what you are saying. Our problem mainly lies in the fact that we receive stock of a specific item and we do not accumulate surplus in a location because it is full, but the system allows it, hence my doubt.

Under review

Thank you for your reply! To ensure a great experience for everyone, your content is awaiting approval by our Community Managers. Please check back later.

Helpful resources

Quick Links

Responsible AI policies

As AI tools become more common, we’re introducing a Responsible AI Use…

Neeraj Kumar – Community Spotlight

We are honored to recognize Neeraj Kumar as our Community Spotlight honoree for…

Congratulations to the November Top 10 Community Leaders!

These are the community rock stars!

Leaderboard > Supply chain | Supply Chain Management, Commerce

#1
Laurens vd Tang Profile Picture

Laurens vd Tang 301 Super User 2025 Season 2

#2
André Arnaud de Calavon Profile Picture

André Arnaud de Cal... 118 Super User 2025 Season 2

#3
Siv Sagar Profile Picture

Siv Sagar 105 Super User 2025 Season 2

Last 30 days Overall leaderboard

Featured topics

Quality order uses default receipt location instead of actual physical receipt location

Product updates

Dynamics 365 release plans