Some of my Items created are showing negative margins. I have had a look at a couple of these and I believe that this is down to when newly created items are copied from an existing item and the Unit cost & Last Direct cost values have not been updated.
In my previous employment using a different system (efacs) after I had created a product, I would run a report that rolled up current costs. This updated the cost values on the newly created product.
At month end I ran this report to update all current costs and then a report to roll over all cost sets from current costs to standard costs.
How can I run a report showing the cost of a new unit I have created?
Is there a report I can run that will update the Unit cost / Last direct cost?
Hi, sorry I'm not sure what your cost method is, you can try running the following batch in a Sandbox environment.
Hope this helps.
Thanks.
ZHU
Was this reply helpful?YesNo
Under review
Thank you for your reply! To ensure a great experience for everyone, your content is awaiting approval by our Community Managers. Please check back later.
Share
Report
All responses (
Answers (
95,729
