Finance | Project Operations, Human Resources, ...

Loop step in workflow

(0) Share

Report

Posted on by Afazal

143

Dear all,

There are 3 steps in workflow, in last step I want system check the specific condition, upon that if condition true workflow ends otherwise move to step 2.

How we can construct the step so that it moves to step 2 every time if condition false.

I have the same question (0)

All responses (2)

Answers (0)

Sort by

Suggested answer

A.Prasanna 8,227 on at

Like (0)

Report
Copy link

Link copied!

if you define your condition, there will be two options one if your condition is true, the other one if is your condition False.
just define what to do when true, then what to do if false that is, Most of the time, the step you are referring to as Step 2 can be defined under the same conditional Block itself.

Regards,

AP

Was this reply helpful? Yes No
Suggested answer

Kevin Xia Microsoft Employee on at

Like (0)

Report
Copy link

Link copied!

Hi,

According to the problem you described, it seems that you can refer to this document: Configure conditional decisions in a workflow - Finance & Operations | Dynamics 365 | Microsoft Learn. A conditional decision is also a point where a workflow divides into two branches. However, the system decides which branch is used to process the document that was submitted. To make this decision, the system evaluates the document to determine whether it meets specified conditions.

Best regards,

Kevin

Was this reply helpful? Yes No