How to pass parameter to PowerApps

(0) Share

Report

Posted on by Community Member

Hello everyone,

I want to embed my PowerApps inside F&O. Any help how to pass the parameter ?

The idea is to get some field value when open Customer detail, while the embedded Apps I have put as a Tile beside the form.

Thanks,

I have the same question (0)

All responses (3)

Answers (1)

Suggested answer

Sukrut Parab 71,699 Moderator on at

Like (0)

Report

RE: How to pass parameter to PowerApps

Did you take a look at link below

docs.microsoft.com/.../embed-power-apps

Was this reply helpful? Yes No
Verified answer

Ludwig Reinhard Microsoft Employee on at

Like (0)

Report

RE: How to pass parameter to PowerApps

Hello WWwong,

At the time you add an app you can select an input context for the app.

The next screenprint gives you an example.

A prerequisite is of course that you app is setup in a way that it can consume this information.

For more specific information about the app setup and configuration, have a look at the following site:

https://powerusers.microsoft.com/t5/Power-Apps-Community/ct-p/PowerApps1

Best regards,

Ludwig

Was this reply helpful? Yes No
Benjamin Closson 20 on at

Like (0)

Report

RE: How to pass parameter to PowerApps

Hello,

So I have attached my power app, but when I do this the form I attached it to does not have control context options to pass to the canvas app. I've done some research and have found that this is possibly because it's a dynamic form? My question is how can I pass record context from my F&O form to the power app (which the function of the power app is to take a photo and attach to the record), so the canvas app is able to save the photo taken to the correct record/form? I've been trying to figure this out for days, so any insight or help will be much apprecieated.

Thank you,

Benjamin

Was this reply helpful? Yes No