Workflow Setup - Send test Email

(0) Share

Report

Posted on by BoGLG

Hi Folks!

I'm doing the initial setup for email for workflow on GP 2018. I'm running into the issue below(see snip). The link below is the only thing I could find out on the Internet regarding this issue specific to GP but it doesn't offer a solution. Any help would be greatly appreciated. Thanks!

https://community.dynamics.com/gp/f/microsoft-dynamics-gp-forum/300099/an-error-occurred-in-ms-net-framework-while-trying-to-load-assembly-id-65625

I have the same question (0)

All responses (6)

Answers (1)

Sort by

Verified answer

Derek Albaugh Microsoft Employee on at

Like (1)

Report
Copy link

Link copied!

Can you successfully run the following against the GP system database:

Exec wfDeployClrAssemblies

When you run this script, it is normal to see warnings, but we shouldn't see any error messages and it should show the script ran successfully.

If it runs successfully, try the Workflow test email again and see if this resolves the error.

Thanks

Was this reply helpful? Yes No
BoGLG 75 on at

Like (0)

Report
Copy link

Link copied!

Hi Derek. Do you mean the Master Database?

Thanks!

Was this reply helpful? Yes No
Suggested answer

Derek Albaugh Microsoft Employee on at

Like (0)

Report
Copy link

Link copied!

No, the system database for Dynamics GP

Was this reply helpful? Yes No
BoGLG 75 on at

Like (0)

Report
Copy link

Link copied!

Sorry if I'm being dim Derek bit are you talking about the DYNAMICS database??

Was this reply helpful? Yes No
BoGLG 75 on at

Like (0)

Report
Copy link

Link copied!

Thanks Derek. It worked!

Was this reply helpful? Yes No
Suggested answer

Derek Albaugh Microsoft Employee on at

Like (0)

Report
Copy link

Link copied!

Sorry I didn't see this earlier........I mention GP system database because some customers may not have the system database actually named 'DYNAMICS'.

Happy to hear the issue is resolved though. Thanks

Was this reply helpful? Yes No